2010 Cadillac Truck SRX AWD V6-3.0L Page 300

2010 Cadillac Truck SRX AWD V6-3.0L Page 300



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Headlamp Replacement (See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/Headlamp Replacement)



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



* Control Module References (See: Testing and Inspection/Programming and Relearning) for headlamp control module replacement, setup



and programming



B257B



DTC B1405, B1529, or B257B



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B1405 02



- Control Module Voltage Reference Output 2 Circuit Short to Ground



DTC B1405 03



- Control Module Voltage Reference Output 2 Circuit Low Voltage



DTC B1405 07



- Control Module Voltage Reference Output 2 Circuit High Voltage



DTC B1529 03



- Control Module Voltage Reference Output 5 Circuit Low Voltage



DTC B1529 07



- Control Module Voltage Reference Output 5 Circuit High Voltage



DTC B257B 03



- Lighting Control Switch Signal Low Voltage



DTC B257B 07



- Lighting Control Switch Signal High Voltage



Diagnostic Fault Information



Circuit/System Description



The body control module (BCM) supplies battery positive voltage to the backlight dimmer switch, which is part of the headlamp switch. When the



backlight dimmer switch is placed in a desired brightness position, reference voltage is applied to the BCM. The BCM interprets this voltage signal,

Comments

Popular posts from this blog

2010 Cadillac Truck SRX AWD V6-3.0L Page 968

With Respect To The C63 AMG

Disclaimer2020 Lincoln Truck MKT FWD V6-3.7L Technical Service Bulletin # 10-6-3 Date: 100412