2010 Cadillac Truck SRX AWD V6-3.0L Page 1313
P0346, P0365, P0366, P0390, P0391, P0627, P0628, P0629 are not set.
* The ignition voltage is more than 8 V.
* The engine coolant temperature is between -100 and +65掳C (-148 and +149掳F).
* The low side fuel pressure is more than 0 kPa (0 psi).
* The engine is not running.
* The DTC runs once for each engine start.
Conditions for Setting the DTC
P0089
The high pressure fuel pump actuator command necessary to maintain the desired fuel rail pressure is +/-2.5 MPa (363 psi) of the command
expected by the controller. The condition exists for greater than 5 s.
P00C6
The ECM detects that the fuel pressure is not rising or has fallen beyond acceptable limits during engine cranking.
P228C
The actual fuel rail pressure is 1.5 MPa (218 psi) less than the desired fuel pressure. The condition exists for greater than 5 s.
P228D
The actual fuel rail pressure is 3.6 MPa (522 psi) greater than the desired fuel rail pressure. The condition exists for greater than 5 s.
Action Taken When the DTC Sets
* DTCs P0089 and P00C6 are Type B DTCs.
* DTCs P228C and P228D are Type A DTCs.
* A message center or an indicator displays Reduced Engine Power.
Conditions for Clearing the DTC
* DTCs P0089 and P00C6 are Type B DTCs.
* DTCs P228C and P228D are Type A DTCs.
Diagnostic Aids
* A restricted fuel feed pipe between the fuel feed pipe fuel pressure sensor and the high pressure fuel pump may set a DTC.
* A condition with the fuel tank fuel pump module or fuel pump flow control module may set a DTC.
* A skewed fuel rail pressure sensor, or an intermittent condition in the fuel rail pressure sensor circuits may set a DTC.
* A leaking or restricted fuel injector may set a DTC.
* A short to voltage in the crankshaft position signal circuit may set a DTC.
* A short to voltage in the camshaft position actuator solenoid valve control circuit may set a DTC.
Reference Information
Schematic Reference
Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics
(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Fuel System Description (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Description and Operation/Fuel System
Description)Fuel System Description (LAU or LY7) (See: Powertrain Management/Fuel Delivery and Air Induction/Description and
Operation/Fuel System Description)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
