2010 Cadillac Truck SRX AWD V6-3.0L Page 1550

2010 Cadillac Truck SRX AWD V6-3.0L Page 1550

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the Q46 Air Conditioning Compressor Valve.

2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 2 and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the

FRT HVAC Fuse circuit open, test or replace the Q46 Air Conditioning Compressor Valve.

3. Verify that a test lamp does not illuminate between the B+ circuit terminal 2 and the control circuit terminal 1.

瀚慖f the test lamp illuminates, test the control circuit for a short to ground. If the circuit tests normal, replace the K33 HVAC Control

Module.

4. Remove the test lamp.

5. Command the A/C compressor ON with a scan tool. Verify the scan tool A/C Compressor Refrigerant Solenoid Valve Command parameter

is 100%.

瀚慖f not the specified value, test the control circuit for a short to voltage. If the circuit tests normal, replace the K33 HVAC Control Module.

6. If all circuits test normal, test or replace the Q46 Air Conditioning Compressor Valve.

Component Testing

Static Test

1. Ignition OFF, disconnect the harness connector at the Q46 Air Conditioning Compressor Valve.

2. Test for 7-15 ohm between B+ circuit terminal 2 and control circuit terminal 1.

瀚慖f not within the specified range, replace the Q46 Air Conditioning Compressor Valve.

3. Test for infinite resistance between each terminal and the Q46 Air Conditioning Compressor Valve housing/case.

瀚慖f not the specified value, replace the Q46 Air Conditioning Compressor Valve.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* HVAC Component Replacement Reference (See: Heating and Air Conditioning/Service and Repair/Removal and Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for HVAC control module replacement, setup, and

programming

P0532

DTC P0532 or P0533

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0532 00

- Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit Low Voltage

DTC P0533 00

- Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit High Voltage

Circuit/System Description