2010 Cadillac Truck SRX AWD V6-3.0L Page 84

2010 Cadillac Truck SRX AWD V6-3.0L Page 84

* The SDM requests the instrument cluster to illuminate the AIR BAG indicator.

* The SDM will store a DTC, however if an event occurs the system will still attempt deployments.

Conditions for Clearing the DTC

* The condition for setting the DTC no longer exists.

* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.

Diagnostic Aid

Note: The following diagnostic aids apply for both current and history DTCs.

An incorrectly installed CPA or incorrectly seated connector can cause a shorting bar to short both control circuits together. Check the connectors

and CPAs if a DTC with symptom byte 02 or 0E is set, to ensure the shorting bars are not causing the circuits to be shorted together. Shorting bars

are used in the locations listed below:

* Passenger instrument panel air bag

* Driver and passenger seat side air bags

* Left and right roof rail air bags

* Driver and passenger seat belt retractor pretensioners

* SDM

* Inline connectors - on the side of the harness connector

* Harness side of the SDM connector

Terminal fretting or incorrectly seated connector can cause an open/high resistance condition. Check the circuit terminals for fretting or incorrectly

seated connector if a DTC with symptom byte 04 or 0D is set. If DTCs of deployment loops which are in the seat DTC B0014 and B0021, can

occur because of stress or damage to the harness due to seat movement. Move the seat to the full extend of travel while using the scan tool to

observe deployment type loop parameters.

If the pretensioner, passenger instrument panel or side air bag has inflated under unexpected conditions and/or DTC with symptom byte 01 is set,

check both control circuits for a short to voltage.

Reference Information

Schematic Reference

SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation/SIR System)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Note:

* Refer to SIR Service Precautions (See: Restraints and Safety Systems/Air Bag Systems/Service Precautions/Technician Safety Information).

* Inspect all terminals for damage or corrosion when disconnecting connectors. Damage or corrosion in the following requires repair or

replacement of the affected component/connector.

- Seat belt retractor pretensioner

- Passenger instrument panel air bag