2010 Cadillac Truck SRX AWD V6-3.0L Page 259

2010 Cadillac Truck SRX AWD V6-3.0L Page 259

Conditions for Setting the DTC

B242A 01

The seat heating control module detects a short to voltage on the heater element control circuits.

B242A 02

The seat heating control module detects a short to ground on the heater element control circuits.

Action Taken When the DTC Sets

The heated seat function for both seats will be disabled.

Conditions for Clearing the DTC

* The current DTC will clear and set a history code 3 seconds after the reference voltage returns to normal operating range and the ignition is

cycled OFF then back to ACC or RUN.

* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Heated/Vented Seat Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Heated/Vented

Seat)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the X2 harness connector at the K29 seat heating control module.

2. Test for infinite resistance between the control circuit terminal 3 and ground.

瀚慖f not the specified value, test the control circuit for a short to ground.

3. Test for infinite resistance between the control circuit terminal 5 and ground.

瀚慖f not the specified value, test the control circuit for a short to ground.

4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.

瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.

5. Verify that a test lamp does not illuminate between the control circuit terminal 5 and ground.

瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.

6. If all circuits test normal, replace the K29 seat heating control module.