2010 Cadillac Truck SRX AWD V6-3.0L Page 313

2010 Cadillac Truck SRX AWD V6-3.0L Page 313

6. Command the appropriate Dedicated Daytime Running Lamp ON and OFF with a scan tool. The test lamp should turn ON and OFF when

changing between the commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuits test normal, replace

the K9 BCM.

7. If all circuits test normal, replace the daytime running lamp bulb.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Passenger Side Headlamp) (See: Lighting and Horns/Daytime Running

Lamp/Service and Repair/Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Passenger Side Headlamp))Daytime Running Lamp

Bulb Replacement (T84, T85 Passenger Side Headlamp) (See: Lighting and Horns/Daytime Running Lamp/Service and Repair/Daytime

Running Lamp Bulb Replacement (T84, T85 Passenger Side Headlamp))Daytime Running Lamp Bulb Replacement (T84, T85 Driver Side

Headlamp) (See: Lighting and Horns/Daytime Running Lamp/Service and Repair/Daytime Running Lamp Bulb Replacement (T84, T85

Driver Side Headlamp))Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Driver Side Headlamp) (See: Lighting and

Horns/Daytime Running Lamp/Service and Repair/Daytime Running Lamp Bulb Replacement (TT6,TT7,TT8 Driver Side Headlamp))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B260E

DTC B260D or B260E

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B260D 01

- Left Daytime Running Lamp and Front Park Lamp Control Circuit Short to Battery

DTC B260D 02

- Left Daytime Running Lamp and Front Park Lamp Control Circuit Short to Ground

DTC B260D 04

- Left Daytime Running Lamp and Front Park Lamp Control Circuit Open

DTC B260E 01

- Right Daytime Running Lamp and Front Park Lamp Control Circuit Short to Battery

DTC B260E 02

- Right Daytime Running Lamp and Front Park Lamp Control Circuit Short to Ground

DTC B260E 04

- Right Daytime Running Lamp and Front Park Lamp Control Circuit Open

Diagnostic Fault Information

Circuit/System Description

When the headlight switch is in the Auto position and the ambient light sensor detects sunlight, the body control module (BCM) will command the

daytime running lamps to illuminate by providing 12 volts to the daytime running lamp control circuit.

Conditions for Running the DTC