2010 Cadillac Truck SRX AWD V6-3.0L Page 62

2010 Cadillac Truck SRX AWD V6-3.0L Page 62

An incorrectly installed CPA or incorrectly seated connector can cause a shorting bar to short both control circuits together. Check the connectors

and CPAs if a DTC with symptom byte 02 or 0E is set, to ensure that the shorting bars are not causing the circuits to be shorted together. Shorting

bars locations are listed below:

* Inline connectors - on the seat belt anchor pretensioner side of the harness connector

* Harness side of the SDM connector

Terminal fretting, an incorrectly installed CPA, or incorrectly seated connector can cause an open/high resistance condition. Check the circuit

terminals for fretting, incorrectly installed CPAs, or incorrectly seated connectors if a DTC with symptom byte 04 or 0D is set.

If the seat belt anchor pretensioner has deployed under unexpected conditions and/or DTC with symptom byte 01 is set, check both control circuits

for a short to voltage.

Reference Information

Schematic Reference

SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation/SIR System)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Refer to SIR Service Precautions (See: Restraints and Safety Systems/Air Bag Systems/Service Precautions/Technician Safety Information).

Note: Inspect all terminals for damage or corrosion when disconnecting connectors. Damage or corrosion in the following requires repair or

replacement of the affected component/connector.

* Seat belt anchor pretensioner

* SDM

* Seat belt anchor pretensioner wiring harness connector

* SDM wiring harness connector

Note: The connector and connector position assurance (CPA) may seat independent of each other. Both the connector and CPA should seat with an

audible and/or tactile click. The CPA isolates the shorting-bars within the connector allowing the deployment circuit to operate properly. Replace

any CPA that is damaged or missing.

If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the

high resistance condition due to terminal fretting corrosion.

1. Observe the scan tool Deployment Loop Resistance parameters. The reading should be between 2.1 and 4.0 ohm.

瀚慖f not within the specified range, refer to Circuit/System Testing.

2. Observe the scan tool Deployment Loop Resistance parameters while moving the harness near each connector listed below. The reading

should stay consistently between 2.1 and 4.0 ohm without any drop outs or spikes.

* F113 Seat belt anchor pretensioner

* Any harness inline

* K36 SDM

瀚慖f the reading is erratic while moving the harness, perform the following: