2010 Cadillac Truck SRX AWD V6-3.0L Page 493

2010 Cadillac Truck SRX AWD V6-3.0L Page 493

* If a seat switch circuit is active in one direction and the switch for the opposite direction is pressed, this DTC will set.

* A short to ground on a switch signal circuit.

Action Taken When the DTC Sets

* A motor output driven in response to a switch considered failed, is deactivated for both directions.

* All memory recall commands are ignored.

* The seat memory control module will respond to any other switch signal that has not set a DTC.

Conditions for Clearing the DTC

* The current DTC will clear and set the code to history, when the fault is no longer present and the ignition is cycled OFF then back to ACC

or RUN.

* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

Diagnostic Aids

* If one of the switch signal circuits is shorted to ground, multiple codes will set.

* If a switch is stuck in one direction and the switch is pressed in the opposite direction, a single code will set.

Reference Information

Schematic Reference

Driver Seat Schematics (See: Body and Frame/Seats/Diagrams/Electrical Diagrams/Driver Seat Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Memory Seats Description and Operation (See: Body and Frame/Seats/Description and Operation/Memory Seats)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, observe the scan tool Seat Memory Control Module seat switch parameters listed below while pressing and releasing the appropriate

seat directional switch. The readings should change between Inactive and Forward/Rearward or UP/Down.

* Driver Seat Cushion Front Vertical Switch

* Driver Seat Cushion Rear Vertical Switch

* Driver Seat Horizontal Switch

* Driver Seat Back Switch

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S64D driver seat adjuster switch.

2. Verify that all scan tool driver seat switch parameters listed below are Inactive:

* Driver Seat Cushion Front Vertical Switch

* Driver Seat Cushion Rear Vertical Switch

* Driver Seat Horizontal Switch

* Driver Seat Back Switch

瀚慖f not the specified value, test the appropriate signal circuit listed below for a short to ground. If the circuit tests normal, replace the K40

seat memory control module.

* Front vertical upward switch terminal A