2010 Cadillac Truck SRX AWD V6-3.0L Page 548

2010 Cadillac Truck SRX AWD V6-3.0L Page 548



瀚慖f less than the specified range, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K73



telematics communication interface control module.



瀚慖f greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the K73 telematics



communication interface control module.



4. If all circuit test normal, replace the B24 cellular phone microphone.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Mobile Telephone Microphone Replacement (See: Accessories and Optional Equipment/Cellular Phone/Cellular Phone Microphone/Service



and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for telematics communication interface control



module replacement, setup, and programming



B2462



DTC B2462 (OnStar/Navigation GPS Antenna)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B2462 01



- Global Positioning System Short to Battery



DTC B2462 02



- Global Positioning System Short to Ground



DTC B2462 04



- Global Positioning System Open



Circuit/System Description



The cellular phone, navigation, and digital radio antenna is connected to the telematics communication interface control module. This module



supplies 5 V to the cellular phone, navigation, and digital radio antenna to power the internal amplifier. When the vehicle is equipped with the



optional navigation radio, a navigation signal splitter is installed to distribute the GPS signal to both the telematics communication interface control



module and the navigation radio. The navigation radio supplies 5 V through the GPS antenna coaxial cable to the navigation signal splitter to power



the internal navigation radio signal amplifier.



Conditions for Running the DTC



Onstar - Telematics Communication Interface Control Module



* Ignition is in the RUN or ACC position.



* System voltage is greater than 9 V and less than 16 V.



* The above conditions are present for greater than 1 second.



Navigation Radio



* Radio On.



* System voltage is greater than 9 V and less than 16 V.



* The navigation radio tests the GPS antenna every 10 seconds.



Conditions for Setting the DTC



B2462 01



The telematics communication interface control module and/or the navigation radio detect a short to B+ on the GPS antenna signal circuit.

Comments

Popular posts from this blog

2010 Cadillac Truck SRX AWD V6-3.0L Page 968

With Respect To The C63 AMG

Disclaimer2020 Lincoln Truck MKT FWD V6-3.7L Technical Service Bulletin # 10-6-3 Date: 100412