2010 Cadillac Truck SRX AWD V6-3.0L Page 523

2010 Cadillac Truck SRX AWD V6-3.0L Page 523

the module. This reference point is biased to approximately 2.5 V. Before the rear seat heating control module will allow heated seat operation, it

checks to see if this biased voltage is shorted to ground or voltage. Once the module verifies that it is not closing to a shorted heating element, it

allows for heated seat operation. The module will then continue to monitor the heating elements for a shorted circuit.

Conditions for Running the DTC

The rear seat heating control module must be powered.

Conditions for Setting the DTC

B2345 13

Any temperature sensor input that remains below 1.5 V for more than 1 second.

Action Taken When the DTC Sets

The heated seat function for both rear seats will be disabled.

Conditions for Clearing the DTC

* The current DTC will clear and set the code to history 3 seconds after the reference voltage returns to the normal operating range and the

ignition is cycled OFF then back to ACC or RUN.

* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Rear Heated Seats Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Rear Heated

Seats)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the X2, X3 harness connectors at the K29R rear seat heating control module.

2. Test for greater than 3.0 kOhms between the signal and the low reference circuits listed below:

* E14F left rear seat cushion terminal 3 X3 and terminal 13 X2

* E14H right rear seat cushion terminal 4 X3 and terminal 14 X2

瀚慖f less than the specified value, test for a short between the signal and low reference circuits. If the circuits test normal, replace the

appropriate E14 seat cushion heating element.

3. If all circuits test normal, replace the K29R rear seat heating control module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Rear Seat Cushion Heater Replacement (40 Percent Seat) (See: Body and Frame/Seats/Seat Temperature Element/Service and Repair/Rear

Seat Cushion Heater Replacement (40 Percent Seat))Rear Seat Cushion Heater Replacement (60 Percent Seat) (See: Body and

Frame/Seats/Seat Temperature Element/Service and Repair/Rear Seat Cushion Heater Replacement (60 Percent Seat))