2010 Cadillac Truck SRX AWD V6-3.0L Page 310

2010 Cadillac Truck SRX AWD V6-3.0L Page 310

* A history DTC will clear after 50 ignition cycles.

Reference Information

Schematic Reference

Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)

Circuit/System Verification

Ignition ON, command the Left Dedicated Daytime Running Lamp and the Right Dedicated Daytime Running Lamp ON and OFF with a scan tool.

The E4C daytime running lamp - left and the E4D daytime running lamp - right should turn ON and OFF while changing between the commanded

states.

Circuit/System Testing

1. Ignition OFF, disconnect the appropriate KR42 daytime running lamp relay.

2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 86 and ground.

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

3. Connect a test lamp between the B+ circuit terminal 86 and the control circuit terminal 85.

4. Command the appropriate Front Park Lamp test with a scan tool. The test lamp should turn ON and OFF when changing between the

commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the K9 BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the K9 BCM.

5. If all circuits test normal, test or replace the KR42 daytime running lamp relay.

Component Testing

Relay Test

1. Ignition OFF, disconnect the appropriate KR42 daytime running lamp relay.

2. Test for 60-180 ohm between terminals 85 and 86.

瀚慖f not within the specified range, replace the KR42 daytime running lamp relay.

3. Test for infinite resistance between the following terminals:

* 30 and 86

* 30 and 87

* 30 and 85

* 85 and 87

瀚慖f not the specified value, replace the KR42 daytime running lamp relay.

4. Install a 15A fused jumper wire between relay terminal 85 and 12 V. Install a jumper wire between relay terminal 86 and ground. Test for

less than 2 ohm between terminals 30 and 87.