2010 Cadillac Truck SRX AWD V6-3.0L Page 1119

2010 Cadillac Truck SRX AWD V6-3.0L Page 1119

The ECM detects that the MAF Sensor Signal parameter is less than 500 Hz for greater than 10 s.

P0103

The ECM detects that the MAF Sensor Signal parameter is greater than 14,500 Hz for greater than 10 s.

Action Taken When the DTC Sets

DTCs P0102 and P0103 are Type B DTCs.

Conditions for Clearing the MIL/DTC

DTCs P0102 and P0103 are Type B DTCs.

Diagnostic Aids

* A steady or intermittent high resistance of 15 ohm or greater on the ignition 1 voltage circuit will cause the MAF sensor signal to be

increased by as much as 60 g/s.

* Depending on the current ambient temperature, and the vehicle operating conditions, a MAF sensor signal circuit that is shorted to the IAT

signal circuit will cause the MAF sensor signal to be skewed or erratic. Additionally, it may cause a rapid fluctuation in the IAT Sensor

parameter.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

J 38522 Variable Signal Generator

Circuit/System Verification

1. Verify that DTCs P0685, P0690 or B1380 are not set.

瀚慖f any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code

Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).

2. Engine running, observe the scan tool MAF Sensor Signal parameter. The reading should be between 1,700-3,800 Hz depending on the

engine coolant temperature (ECT).

3. A wide open throttle (WOT) acceleration from a stop should cause the MAF sensor parameter on the scan tool to increase rapidly. This

increase should be from 2-6 g/s at idle to greater than 180 g/s at the time of the 1-2 shift.

4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Circuit/System Testing

1. Verify that DTCs P0685, P0690 or B1380 are not set.